3-in-1 Mic
DownloadBecause of the fact that silicone rubber, rosco projection screen and acrylic are very static I wanted to point out that you shouldn't saw or cut acrylic or polycarbonate in the same room where you store the rosco or the silicone rubber. The tiny acrylic particles stick to everywhere, so you will...
I wanted to give 2 tips regarding handling projection screen and Rosco in particular. I don't know if this applies to other projection screen materials, but because we have experimented with Rosco Grey a lot, I figured I should post it here. For some people it might be common sense, but I'm sure...
I have found out that covering your silicone rubber sheets while curing gives a better end result. This way small dust particles in the air can't settle and cure into the surface of the silicone rubber. Usually these small particles cure into the silicone rubber and therefore create little...
I've been rather busy lately, so there hasn't been a lot of updates.
We received 4 samples of rear projection screen from Teknilux in Sweden. Eventhough the black sample had a very nice image (a bit better then the other 3), it was totally useless with the silicone rubber sheet. No blobs at all. The 3 other samples worked very well. But the material is less sturdy...
Peter Bomark my colleague of the Hardware Design and Construction Department developed a couple of conceptual 3d models for multitouch devices. I posted two of them below.
We ordered a new camera for our research. It's the Unibrain Fire-i™ Digital Board Camera. And this baby is sweet. After having thoroughly tested the Philips SPC900NC, we definitely wanted to test out a firewire cam, because of the general knowledge of a firewire cam being faster then a USB cam....
